Are your garage doors malfunctioning? If your garage door isn’t working as efficiently as it did in the past it is likely to be experiencing problems. Sensors, which are located on the opposite side that of your garage door, have an important part in the garage’s operation. The two components of the door, the transmitter (sends signals) and the receiver (receives the signals that shut or open the door) are in charge of ensuring an optimal performance. However, sensors could be damaged in the event that they’re not in alignment. You’re welcome; we’ll be discussing ways you can align your garage door sensor in the following article.
How to How Align Garage Door Sensors
Make sure to grab these tools before you set the sensors in alignment:
- Lever
- String
- Screwdriver
- Electricity-resistant gloves
It is essential for garage door’s sensors to be aligned so that they function correctly This is the best way to do it:
1. Unplug the Power Supply
Since this step requires working with wires, wear your electricity-resistant gloves to stay safe. After you have put on your gloves take off the power supply to the garage door’s sensors by shutting off the switch. In addition, you could use the breaker box in your home to turn off the fuse on your garage’s door.
2. Release the screws that hold the Sensors
The real work begins. You’ll need loosen the screws on the mounting brackets which hold the sensors. After that, you’ll have to rotate them in an clockwise until they’re loose enough for them that they’re loose. Keep in mind that getting rid of the brackets completely isn’t a good idea because you’ll need to slide them down and up again later on. If you feel difficultes and you want to hire a professional Gate Installation Hialeah or gate repair experts.
3. Slide the Sensor downwards
It will be easier to move the bracket upwards and downwards once the screws have been loosen. Thus, use only your hands to move it down. Make sure to keep it sliding to the lowest point you can and ensure that the sensor is in the bracket during. If you are using wrenches, they could leave scratches to the sensor, which could interfere with the function of the sensor.
4. Join to the String & Tie the Knots
The next step is the primary step of the process of aligning the garage door sensors. Before you begin, check the sensors to ensure that they’re at the right position and the correct height. Then, tie both ends of your string around the sensors and to their mounting brackets. The success of the process is entirely dependent on the project. So, the string should be as straight as is possible.
5. Make sure the string is level
Place your level on the floor and set it under the string. Check to see whether it is level through the entrance. Place your level on strings for couple of minutes. Should the string be level it is possible to continue by completing your next move. If not, continue to adjust until you see how the sensors have been aligned.
6. Lock the Screws
If both levels are aligned perfectly in accordance with your leveler then you can begin tightening the screws. It is important to tighten them to the point that the door’s sensor won’t move in response to pressure. Then, test with the leveler to determine whether the sensors are aligned.
7. Test the Sensors
Then switch the power off and then test the sensors to determine whether they work effortlessly. If they aren’t working, or you’re experiencing other problems, you should contact an Gate Operator Repair Hialeah expert for your garage door opener.
